Platinum Protection Plan

Heating and Air Conditioning

• Check Thermostat Operation (Spring and Fall)
• Inspect and Test Condensate Drainage System (Spring)
• Clean and Cycle Condensate Pump (Spring)
• Check Refrigerant Pressures (Spring)
• Measure Temperature Drop Across The Coil (Spring)
• Clean and Check Contactors (Spring)
• Inspect Evaporator Coil and Condensate Pan (Spring)
• Check and Test All Emergency Float Devices (Spring)
• Inspect and Adjust Blower Components (Spring and Fall)
• Take Supply Air Temp (Spring and Fall)
• Take Return Air temp (Spring and Fall)
• Check Zone System (If Applicable) (Spring and Fall)
• Check Duct Work (Spring and Fall)
• Inspect Condensing Unit (Spring)
• Check Condenser Fan Blade (Spring)
• Check Compressor Mounts and Noise Level (Spring)

• Check COA (Condenser Over Ambient) (Spring)
• Clean or Replace Air Filters (Spring and Fall)
• Lubricate Motors and Bearings, If Not Self-Lubricating Motors, and If Accessible (Spring and Fall)
• Test Safety Controls (Spring and Fall)
• Test Pressure Switches (Spring and Fall)
• Measure Volts and Amps On The Motors (Spring and Fall)
• Check Condition of Electrical Wiring (Spring and Fall)
• Check All Condenser Electrical Connections (Spring)
• Clean and Adjust Burner Assembly (Fall)
• Monitor Flue Draft (Fall)
• Vacuum Out The Heat Exchanger (Fall)
• Test Heat Exchanger for Cracks and Leaks (Fall)
• Measure Temperature Rise (Fall)
• Measure Gas Pressure (Fall)
• Check Main Disconnect (Fall)

Water Treatment Bonus Coverage

Softener

Clean nozzle & injector, check function of flow meter, cycle system through backwash, check salt level, check functions of brine assembly, examine condition of bypass, test water to make sure it’s soft, set regeneration time and frequency.

Neutralizer

Examine condition of bypass, verify calcite levels in tank, siphon excess water, refill with necessary level of calcite, flush unit & rinse, reset timer & check function of valves, put into fast rinse and flush to drain, test Ph value of water.

Birm Iron Filter

Examine condition of bypass, check for adequate function, siphon excess water, examine condition of birm In tank, reset system and place into fast rinse to clean, test water, set regeneration time & frequency

R.O. Units

Isolate and drain down system, pull out and replace membrane, replace pre- and post-filters, flush cannisters with chlorine to prevent bacteria, check pre-charge of storage tank, refill system (may take up to 24 hrs for full pressure to be restored).

Green Sand Iron Filter

Clean nozzle & injector – check for adequate function, siphon dirt & excess iron from tank, top-off pot perm in tank, clean felt in pot perm tank as needed, reset system and place into fast rinse to clean, test water, set regeneration time & frequency.

U.V. Units

Disconnect power, isolate, & inspect system, depressurize, inspect and clean quartz sleeves, replace bulb, inspect pre-filters (where applicable), turn on inlet valves checking for leaks, restore power, check LED indicator, restart system.

Sediment Filters

Remove & clean canister, lube o-ring, remove and replace existing filter, flush at sink until it runs clear (carbon filter only).

$449.00 Platinum Protection Plan

Lock in your rate now and receive a $10 price reduction each year when you renew your plan. The SolvIt Home Services Platinum Protection Plan covers all of the systems listed. No matter how many systems you have, we’ll cover all of them at the same low price. And, you’ll receive a lifetime warranty on any replacement parts that we install, including labor.

Bonus Water Treatment Coverage